CLEAR ACRYLIC CASE FOR ZERO4U AND RASPBERRY PI ZERO (V1.2 OR V1.3)

ZERO4U-CASE

New product

£4.49

A transparent acrylic case that can hold Zero4U and Raspberry Pi Zero together.

More details

Add to wishlist

10 Items

RODUCT DESCRIPTION

This acrylic case is built with 6 pieces of clear acrylic sheets, one plastic M2 standoff and 2 plastic M2 screws. It can hold your Raspberry Pi Zero (V1.2 or V1.3) and Zero4U (4-port USB hub for Zero) together. The acrylic sheets are 3mm thick and the case can protect your Raspberry Pi Zero and Zero4U very well.

There is a window for GPIO header, so you can still access all GPIO pins.


PACKAGE CONTENT

  • Acrylic Sheets x 6
  • Plastic Screw M2 6mm x 1
  • Plastic Screw M2 15mm x 1
  • Plastic Standoff M2 20mm x 1

The Zero4U Hub is sold seperately. 


 STEP BY STEP ASSEMBLY GUIDE

There are six acrylic plates in the package. Each acrylic plate has protective membrane on both surfaces, and you will need to remove the membrane before going to the next step.
Please notice that we replaced one plate later to have the window opened for camera connector on Raspberry Pi Zero V1.3:
new_piece
Use tweezers or fingernails to peel off the membrane on both sides carefully, then you will see the smooth surfaces.
Before continuing, please mount Zero4U on your Raspberry Pi Zero, back-to-back and then fix the four corners with the plastic screws, spacers and nuts in Zero4U’s package.
Now we can start from the piece that shown in the figure below. Place the short screw at the bottom, let it go though the small rounded hole and then fix the plastic standoff. Make sure to mount the standoff at the correct surface, the rounded window should be on its right, as shown in the figure.
Now we put the acrylic sheet on the side of Raspberry Pi Zero, which has two micro USB ports. The plastic standoff should go though the space between Zero4U and Raspberry Pi Zero.
Place it up side down, and put the 4 pieces around your Raspberry Pi Zero and Zero4U. Please pay attention to the sheet that has window for SD card, and make sure it gets placed in correct direction, or the SD card slot could be covered by mistake.
Also pay attention to the other side, for Raspberry Pi Zero V1.3 there is a camera connector, which should be placed in the window:
camera_connector_window
Put on the last piece and place the long screw into the small hole. Once it aligns with the plastic standoff between Zero and Zero4U, use your screw driver to tighten it.
All done! Here is how it will look like:
You can connect the power supply to the micro USB port, and it is ready to rock.
all_ports_connected
Grade 
2017-03-10

Awesome neat case

Perfect fit fast delivery

    Grade 
    2016-12-30

    Happy with case.

    Had to look over assembly guide once but not too complicated to assemble. Keeps everything in place.

      Grade 
      2016-12-28

      Good complement

      A touch fiddly to assemble but once done, solid bit of kit that can survive the odd drop or two!

        Write your review!

        Write a review

        CLEAR ACRYLIC CASE FOR ZERO4U AND RASPBERRY PI ZERO (V1.2 OR V1.3)

        CLEAR ACRYLIC CASE FOR ZERO4U AND RASPBERRY PI ZERO (V1.2 OR V1.3)

        A transparent acrylic case that can hold Zero4U and Raspberry Pi Zero together.

        22 other products in the same category: